Surface Bond HD Color Asphalt and Concrete Coating - 4 Gal

High performance industrial grade coating used by thousands of municipalities and commercial customers for parking lots, playgrounds, driveways, bike lanes, pedestrian and vehicular areas, pedestrian malls, and traffic flow pattern marking. Can be applied on asphalt and concrete substrates.

Easy to apply application. Open, mix in the Surface Bond HD color pigment, and roll out! This unique heavy duty coating rolls on like paint, but has 20x the performance and life span. It’s low VOC, water-based formulation has almost no odor or toxic chemicals and is safe to use in all 50 states. It meets all USA environmental requirements. Surface Bond HD helps to rejuvenate concrete and asphalt surfaces, making them look ‘like new’, and adding significant life and protection from the elements. Surface Bond HD uses special nanotechnology bonding agents to assure a firm bond to your surface and long life. Fully UV protected from the elements and can withstand rain, snow, hail, salt, chemicals, fuels, oils, etc. Can be used on patterned or stamped concrete and asphalt and safe for vehicular and parking lot use. Additonally it will help to protect against freeze damage from water intrusion. Surface Bond HD is color-stable, flexible (allowing for wide temperature swings), and easily recoatable in the future with little prep other than a standard cleaning.

Fast drying times allow you to get back on to your floor the same day! This products reauires 2X coats. Recoat time is 30 mins -1 hour after initinal coat and will vary depending on temparetue and RH. Allow 8-12 hours for full cure (Cooler temperatures may affect cure times). Wait 24 hours for vehicle traffic.

Request a Surface Bond sample chip today!

Each Kit includes 4 Gal of Surface Bond HD shipped in a 5 Gal mixing bucket and 1 pint of color pigment. Mix each pint of pigment into the 5 Gal pail for appx 5 minutes. Use our Surface Bond HD Pail Mixer or any standard metal sprial mixer or mud mixer. Apply the first coat by roller or spray. This product has a long working time unlike epoxy. Standard nap rollers can be used to apply the coating. This product can also be squeegeed and backrolled to help faciliate spreading of material. If using squeege ensure to use a flat squeegee. If using on stamped concrete it is best to use a thicker nap roller (ie. 1/2″ – 3/4″ NAP). Concrete substrates should also be prepped using a cid etch to help balance the PH levels of the floor. Surface Bond Adhesion Promoter can also be used prior to Surface Bond HD application to help promote a strong and lasting bond.

Coverage is 60-70 sq ft/gal (240-280 square feet per pail/coat). Minimum of two coats is required. Please note that during the initial coat your coverage will be lower due to the absorption of the surface, but subsequent coat coverage will be higher since the surface is now sealed.  Additon of additional coats beyond two coats will add life span and durability. A maximum of 4 coats can be applied. Coverage may vary based on surface.

Available in over 18 base colors and 100+ additional colors when base colors are mixed together. Refer to the color chart to view them all! Please contact the sales department to inquire how much of each colorant would be needed for your project. Please note that pricing on special order colors will vary based on color choice.

*Note: not all colors on color chart are available online. If there is a color on our color chart that you would like to purchase, please contact our office.

IMPORTANT: Do not apply to pavement surfaces that have previously been sealed with coal tar or asphalt based sealers.

**PLEASE ALLOW 1-2 WEEKS LEAD TIME FOR OUR SURFACE BOND PRODUCTS**